Install the new expander in place by sliding it along the bottom of the door.Measure the expander and buy one with the same length.Loosen the screws that keep the expander in place.Using your pliers, pinch the metal at the ends of the bottom of the door to secure the sweep in its place.Tip: Putting a small amount of liquid dish soap will make this task smoother. Slide the new door sweep into the groove until it reaches the other edge of the door.Clean the bottom side of the storm dorm.You might need to use pliers if the rubber is attached too tightly. Grasp the rubber seal at one end of the door and pull it out from its groove.Here are the steps on how to replace them. It has a metal casing and the sweeps are molded inside. It is simply attached to the bottom of the storm door. It is a rubber seal that isn't enclosed inside an expander. There are two kinds of seals at the bottom of a storm door. That's why it is important to have the rubber seal at the bottom replaced immediately once it is damaged or when it is already worn out from years of service to your home. This means you get to save on your energy bill! And best of all, your home is more energy-efficient. You won't be bothered by hot or cold air coming from the outside and it'll help maintain the temperature inside your house at a comfortable level. The door sweep will also intercept drafts. ![]() It will effectively prevent bugs, dirt, water, moisture, and other unwanted particles from getting inside your home and causing damages. This is essential in keeping your storm door properly sealed. ![]() The rubber seal or door sweep on your door can be found around its bottom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |